B 101 G - Guidelines for installation, servicing, safety and storage
B 101 G Installation & Maintenance
The screw-type compressor can be mounted directly on the separator tank. The connections for the compressor outlet and the oil injection should consist of steel tubing with generous dimensions. Attention is drawn to ROTORCOMP product information concerning screw-type compressors.
The geared compressor should only be fitted from the front end. All fastening screws must be fitted according to the instructions and be in exact alignment. Before starting the compressor and transmission system for the first time, fill up with about one litre of oil. The minimum oil injection pressure should be at least 1 bar in front of the compressor in each phase of operation.
This component does not constitute a finished product in the legal sense of the term. Only after installation and in connection with other components does it form a final product - e.g. a screw compressor system. Its proper installation is thus the responsibility of the system manufacturer. Screw compressor systems must be installed and operated in accordance with the currently valid safety and accident prevention regulations.
There must be an adequate corrosion protection procedure carried out when stored for a longer period of time. All of the components must be protected against damage from jolting and impact. Any transportation damage must be dealt immediately with the forwarding agent.
Store in dry rooms without acid vapors, alkalis or other chemicals 1,5 m (2 yds) away from radiators and at least 0,20 m (8 in.) above storage room floor. Storage not below +20 °C and at max. 50% relative air humidity.
The points listed above are the prerequisites for safe operation. If you have additional technical inquiries please get in touch with ROTORCOMP.
ROTORCOMP components comply with the latest technical standing. However, in the interest of further technical development, we reserve the right to modifications.